ABS 5
General
The ABS 5 has self-diagnosis capabilities. The following diagnosis functions are possible:
- Read identification
- Read/clear defect code memory
- Read input signals
- Activate components
Diagnosis communication takes place via a bi-directional diagnostic link (single-wire interface).
Important!
The ABS 5 control unit features a non-volatile defect code memory. In warranty cases, print out test code and do not delete defect code memory!
Defect Code Memory
Under certain, non-plausible operating conditions, two or three speed sensor defects with the same ambient conditions can be stored in the control unit although there is no defect.
Following causes are possible:
- Wheel balanced with a finish balancer (ignition lock position 2)
- Towing at an axle (ignition lock position 2)
- Operation on high-speed roller dynamometer test stand
During diagnosis, the defect code memory is not updated before the ignition is switched off and then switched on again.
Activate components
Components cannot be activated in the case of a current defect ("current defect").
There is no feedback to the tester relating to successful activation.