Rail-pressure sensor DDE6.0/6.2/6.3
The rail-pressure sensor registers the fuel pressure in the rail and serves as a measured value transducer for volume metering and rail pressure control.
The rail-pressure sensor is fitted on the rail in the M47TU/2 and M57TU/2. On the M67TU, the rail-pressure sensor is mounted on the fuel-distribution pipe.
The DDE control unit supplies the sensor with ground (M_RDS) and a supply voltage of 5 V (U_RDS).
The pressure is picked up by a hole in the sensor and a corresponding measurement voltage (A_RDS) is sent to the DDE control unit).
Troubleshooting
If the rail pressure sensor is defective, the following faults may be stored:
- 3F30, Signal circuit break or short circuit to positive
- 3F31, Signal short circuit to earth
The rail-pressure sensor is also monitored as regards non-permitted offset (faults 3F40 and 3F41) when not under pressure.
Consequences:
- the DDE outputs a substitute value.
- the injection volume is limited.