Mini_DV6 glow system
Glow system, component functions:
The glow system implements the preglowing. The ”preglowing” considerably improves the starting capability of the diesel engine at low temperatures. The heat contribution is made by the glow plugs into the individual cylinders. In cold cylinders, the compression pressure and thus the temperature of the air in the cylinder is low. The present MINI diesel engine uses an electronic combustion preheating control unit; this is not integrated in the diesel engine management system but rather in a rectangular (approx. 70 mm x 30 mm x 30 mm) external component. This combustion preheating control unit uses internal power electronics to control the heat output of the four glow plugs in the individual cylinders. The principal phases of the glow process are as follows:
- Preglowing; heating the glow plugs to operating temperature
- Standby glowing;
- Start glowing; during warming up of the engine
- Post-glowing phase; after the starter motor discharge phase
- Intermediate glowing;
Service instructions and component information:
An 8-pin combustion preheating control unit is fitted in the present engine. Viewed in the direction of travel, the installation location is on the right-hand side adjacent to the exhaust gas recirculation hose. The following target values apply:
- Cable and plug connection:
Pins 1, 2, 6, 7: power supply, ”heating” the glow plugs in the cylinders
Pin 5: Earth
Pin 3: diagnosis lead (CDE)
Pin 8: communication link (DIAG)
Current consumption: peak currents up to 30 Amperes; normal range at approx. 10 Amperes
(nominal values: approx. 10 +/- 1.5 Amperes after 4 seconds) - Operating voltage: 8 to 18 Volts (nominal value: 11 Volt)
Diagnosis instructions:
The diagnosis of the glow system meets the requirements in accordance with on-board diagnosis.