Renewing the control module
After the DSC control module has been replaced, the following work must be performed in this order.
1. Coding
2. Calibration of the DSC sensors
- Steering angle sensor
- Rotation rate sensor
- Lateral-acceleration sensor
3. End-of-line test (without driving curves with pressure sensor test)
The end-of-line test serves to check the DSC sensors in the plant at the end of the assembly line. This test is active on every factory-new DSC control module and it must therefore also be run every time a factory-new DSC control module is fitted.
Procedure for end-of-line test:
The sequence varies depending on the vehicle model and control-module version. Due to the identification of the DSC control module by the DIS tester, the following procedure results.
- Disconnect the diagnostic plug to exit from the diagnostic mode.
- Switch off the ignition for at least 10 seconds to perform a reset of the DSC.
- Switch on ignition: After ignition on, the DSC indicator lamp, the ABS indicator lamp and the general brake warning light come on simultaneously (the end-of-line test is active).
- Standstill calibration: Within the first 2 seconds after ignition on, the control module automatically runs the standstill calibration.
- Check of the pressure sensor: After the standstill calibration, you must press the brake pedal strongly within 20 seconds (if necessary, start the engine).
The end-of-line test has been completed successfully when the DSC indicator lamp, the ABS indicator lamp and the general brake warning light come on.
Faults during end-of-line test:
If the end-of-line test is not concluded successfully (all indicators remain on), the DSC is not working and at least the fault ”6D end-of-line test not carried out” is entered in the fault memory with the status ”currently present”.
The end-of-line test must be repeated. If the end-of-line test fails a second time, it is likely that there is a fault in the area of the rotation rate and lateral-acceleration sensor. Run troubleshooting.