Optical test on the byteflight bus system
The byteflight bus system has a star-shaped structure. The individual satellites (= control modules with/without sensors) are interconnected across a certain control module (the star connector) by means of fibre-optic cables. Depending on the model series, the star connector is either the Safety and Information Module or the Safety and Gateway Module. There is a transmission and a reception module (transmitter and receiver) as a unit in each satellite for connecting to the byteflight. The unit has an integrated transmit and receive diode.
Main functions
Plug-in connections in the safety system
Fig. 1 shows the various plug-in connections of the safety system. The star connector has 6-pin sockets for mounting the 6-pin fibre-optic cable connectors. The connection between the star connector and the satellites is by means of fibre-optic cable. In the case of the door satellites, there is an additional isolation point between the door and frame of the vehicle. The satellites are supplied by the star connector with a voltage between 9 V and 11 V. However, the connector for the power supply is not shown in Fig. 1.

Fig. 1: Overview of the plug-in connections of the safety system
I: Star connector |
II: Satellite |
1: Satellite socket |
2: Satellite connector |
3: Star connector socket |
4: Star connector connector |
5: Door socket |
6: Door connector |
7: Power supply from star connector to satellite |
8: Fiber Optics |
No communication with satellite possible
If no communication is possible with a certain satellite, this can be caused by the following:
- Power supply of satellite defective
- Transmitter or receiver of star connector defective
- Transmitter or receiver of satellite defective
- Fibre-optic cable between star connector and satellite defective
If the power supply of the star connector is defective, no communication with the relevant satellite is possible. It is also the case that no communication is possible with any other satellite (and the star connector). In this case, the cause of the fault must always be searched for first at the star connector!
Prior to each manual optical test, the power supply of the control modules suspected of being defective must be checked. The satellites are supplied by the star connector with a voltage between 9 V and 11 V.
Service functions
Notes on safety
All work on the airbags must be carried out with the battery clamped off!
Only connect and disconnect byteflight bus system control modules with the fuse of the star connector removed!
If a fibre-optic cable on the byteflight has to be repaired, it must be borne in mind that there may only be one join in a fibre-optic cable. If there is already a join due to a door connector, the fibre-optic cable must not be repaired. In the case of a defect, the fiber-optic cable must be replaced!