WDSBMW wiring diagrams
← Back

Initializing the power windows

 

Functional description, see BMW Technology:

TIS -> Document -> SI Technology -> Enter SBT Number

JBBF, SBT: 61 0504 095

FRM, SBT: 61 0404 094

Initializing the power windows

On initialization of the power windows, two parameters are learned by the control module:

Preconditions

The following requirements must be met for the initialization to be carried out without faults:

The initialization can be carried out using the control switch in each door or the power-window switch block in the driver's door.

Deleting the initialization

Deleting an initialization and subsequent re-initialization can remedy sporadic incorrect shutdowns in the power window automatic mode (toll mode).

Execution

Open the window of each door completely. Press and hold the control switch completely (switch position: automatic mode) for longer than 15 seconds and less than 20 seconds

Deletion of the initialization was successful when the automatic mode (toll function) is no longer possible for the 'close window' function.

Carrying out the initialization

The re-initialization is carried out as follows:

The initialization was successful if the window can be opened and closed without faults in the automatic mode (toll mode).