Knock Control
Knock control in the S54
Tasks of the knock control system
Operation of an engine with knocking combustion over a prolonged period can lead to serious damage. Knocking tendency is increased by:
- Increased compression ratio
- High cylinder charge
- Poor fuel quality (RON/MON)
- High intake air and engine temperatures
The compression ratio can also reach excessively high values due to deposits or production-related scatter.
On engines without knock control, these unfavorable influences must be taken into consideration in the ignition design by providing a safety distance to the knock limit. However, this results in unavoidable losses in efficiency in the upper load range.
The knock control can prevent knocking engine operation. For this purpose it retards the ignition timing of the affected cylinder(s) (cylinder-selective) only as far as necessary and only if there is an actual risk of knocking. In this way, the ignition characteristic map can be adapted to the optimum consumption values without having to take the knock limit into consideration. A safety distance is no longer necessary.
The knock control system carries out all knock-related corrections to the ignition timing and enables perfect operation also with regular grade fuel (minimum RON 91).
The knock control provides:
- Protection against knocking damage also under unfavorable conditions
- High efficiency due to optimum utilization of the fuel quality and consideration of the relevant engine status
- Logistics advantages with regard to fuel availability
- Lower consumption and higher torque over the entire upper load range (corresponding to the fuel quality used).
Design of knock control system
The engine is equipped with a cylinder-row-selective, adaptive knock control system. A knock sensor detects the combustion knock. The sensor signals are evaluated in the DME control module.
The knock sensor is a piezo-electric structure-borne noise microphone. It picks up the structure-borne noise and converts it into voltage signals.
Function of the knock control system
If knocking occurs, the ignition is retarded for a certain number of working cycles and then gradually approaches the original value. The retard setting can be controlled individually for each cylinder bank (cylinder bank selective).
In the event of failure of the knock sensor, an entry is made in the fault memory of the engine control module. In the case of fault, the engine is protected by constant retard setting of the ignition timing.
Self-diagnosis and emergency operation of the knock control system
Self-diagnosis of the knock control system includes following checks:
- Check for sensor signal interference/line break, plug connector defective etc.
- Self-test of entire evaluation circuit
- Check of basic engine noise level detected by the knock sensor
The knock control system is switched off if a fault is found during the course of one of these checks. The emergency program adopts the task of controlling the ignition timing. At the same time, a defect code is stored in the fault memory. The emergency program ensures damage-free operation as from minimum RON 91. It depends on the engine load, speed and temperature.
Note:
Three knock sensors are fitted in the S54 engine. Sensor 1 is assigned to cylinders 1 and 2; sensor 2 is assigned to cylinders 3 and 4; and sensor 3 is assigned to cylinders 5 and 6.