Transmission adaptation on the twin-clutch transmission, DKG.
With the service function 'transmission adaptation', the end stops and neutral positions of the gears are learned.
The transmission adaptation must be carried out after the following task:
- Replacing the mechatronics
The service function 'transmission adaptation' is fully automated. There is a continuous output of the state. No other interventions on the part of the operator are necessary.
The instructions of the BMW diagnosis system must be followed without fail, as this is the only to ensure a correct operation.
The following environmental conditions must prevail when carrying out the clutch adaptation:
- Transmission fluid temperature 0 - 90 °C
- The engine must be running
- Parking brake activated
The environmental conditions must be kept constant for the entire duration of the service function (approx. 30 s).
Sequence of the service function:
- Check the environmental conditions
- Start transmission adaptation (automated sequence)
- Transmission adaptation runs automatically; there is continuous output of the state. If the service function aborts, an fault message is issued. The operator is then asked to restart the service function.
- After successful completion of the service function, the 8 learned values are displayed.
- Store the adaptation values in the transmission control.
To do so, the gear selector switch must be in position N, the engine must be switched off and terminal 15 must be switched on.
Note:
During the service function 'transmission adaptation', the end stops and neutral positions of the gears are reached. This means that noises and severe jolting can occur.