Oil balancing on the twin-clutch transmission, DKG.
With the service function 'oil balancing', the oil level of the transmission is checked and corrected if necessary.
The oil balancing must be carried out after the following tasks:
- Replacing the clutch, oil pump
- Replacing the mechatronics
- Replacing the oil pump
- Replacing the transmission (complete)
- Repair / replacement of the transmission fluid cooler, oil cooler lines, thermostat, water-oil heat exchanger and seals
- Opening / replacing the oil balancing screw
- After all work on the open transmission
The instructions of the BMW diagnosis system must be followed without fail, as this is the only to ensure a correct operation.
The following environmental conditions must prevail when the oil balancing is carried out:
- Transmission fluid temperature at start less than or equal to 32 °C
- The engine must be running
Sequence of the service function:
- Check the environmental condition ”engine running”
- The parking lock is automatically engaged
- Output of transmission fluid temperature
- Increase in the engine speed by operator intervention. The engine speed must exceed 2000 rpm for one minute to distribute the oil evenly in the transmission.
- Check operation of the accelerator pedal. The accelerator pedal must not be pressed from this point in time onwards.
- Automatic system pressure limitation, activation of maximum cooling and engaging first gear
- Run the oil balancing according to the repair instructions
- Open the oil balancing screw
- Overfill the transmission if no oil emerges with balancing conditions met
- Let the transmission ”bleed”
- Close the oil balancing screw at an oil temperature greater than 30 °C
- The oil temperature must not exceed 40 °C before closing the oil balancing screw!
Otherwise, insufficient filling is possible!
- Terminate the service function by pressing the brake pedal