WDSBMW wiring diagrams
← Back

Lambda control

 

Lambda probes

For oxygen-sensor control, the S65 is fitted with 2 control sensors (LSU 4.9) and 2 control sensors (LSF 4.2).

Dynamic check of oxygen sensors before catalytic converter

This system test determines by means of lean/rich shifts in the air/fuel mixture the deviation integral for the oxygen sensors before catalytic converter from the target Lambda value. The diagnosis result is a value from 0 to 1 per bank. The higher the value the better the condition of the sensor.

Target value: diagnosis result > 0.3

If the value is less than 0.3, the vehicle must be driven:

Before driving, the engine has to run without interruption for 18 minutes so that the diagnosis can run. The engine must not be switched off before the journey is completed, as otherwise the 18 -minute count starts from the beginning.

If no oxygen-sensor fault is stored in the DME after the road test, the oxygen sensors are OK. If a fault is stored, the sensor concerned must be replaced

Catalytic converter diagnosis

The vehicle must be driven for the catalytic converter diagnosis:

Before driving, the engine has to run without interruption for 18 minutes so that the diagnosis can run. The engine must not be switched off before the journey is completed, as otherwise the 18 -minute count starts from the beginning.

If no fault (catalytic converter conversion) is stored in the DME after the road test, the catalytic converters are OK. If a fault is stored, the engine-proximate catalytic converter concerned must be replaced. Before replacement of a catalytic converter, it must be ensured that the oxygen sensors have no faults!