DDE7.3 control module
Important!
Follow these instructions carefully when replacing a DDE control module!
.
- Replacing a control module with which communication is still possible.
Before removing the control module, the service function 'Data recovery' must be run to recover data from the control module. These data are cached and must be restored after installation of the new control module. - Replacement of a control module with which no communication is possible.
After replacing the control module, the injector volume calibration must be carried out. The codes of the injectors fitted in the engine must be stored on the new control module. To perform this operation, use service function ”injector volume calibration”.
Introduction
The control-module plug is modular and has five plug modules.
Ambient-pressure sensor
The ambient-pressure sensor is integrated in the DDE control module and cannot be replaced separately.
Electronics box fan (E-box fan)
No E-box fan is fitted on the F01 with N57.
Troubleshooting
The DDE control module is monitored for various internal faults. If an internal fault occurs, the DDE control module must be replaced.