Pedals
Brief description of components
Stop lamp / stop lamp test switch
Two switches are fitted on the brake pedal which supply the following signals:
- S_BLS brake-light switch
- S_BLTS stop lamp test switch
The CAS control module evaluates the signals for the purpose of registering brake operation. The CAS control module sends the signals across the CAN bus to the DDE control module.
The stop lamp switch connects to ground, the stop lamp test switch connects to positive. Both signals are checked for plausibility.
The following table shows how the signals behave:
|
Brake-light switch is |
Brake-light test switch is |
Brake pedal operated |
open |
closed |
Brake pedal not operated |
closed |
open |
Clutch mode (manual transmission only)
A switch is fitted on the clutch pedal for the purpose of registering clutch operation on vehicles with manual transmissions.
The CAS control module evaluates this signal for the purpose of registering clutch operation. The CAS control module sends the signal across the CAN bus to the DDE control module.
The clutch switch switches to ground.
The following table shows how the signal behaves:
|
Clutch switch is |
Clutch operated |
open |
Clutch not operated |
closed |
Accelerator pedal module
The position of the accelerator pedal is reported to the DDE control module via analog voltage signals. The signals are generated by two pedal-travel sensors in the pedal-position sensor.
The pedal-position sensors take their 5 V power supply and earth connection from the DDE control module. Depending on the operating angle, the pedal-position sensors return various voltages to the DDE control module. The DDE control module converts the voltage signals into the accelerator pedal position.
The signal of pedal-position sensor 2 always has half the signal voltage of pedal-position sensor 1.
The idle, full throttle and kick-down positions are detected by way of voltages of the pedal-position sensors.
Troubleshooting
The pedal-position sensors are monitored for short circuit and interrupt as well as for plausibility in relation to one another.