WDSBMW wiring diagrams
← Back

Seat calibration

Seat calibration includes:

Important notes

Standardization

The calibration can be carried out on both mechanical end stops. Depending on the function, the necessary calibrations can differ. Seat calibration can be carried out by means of a diagnosis job or manual seat adjustment.
For rear seats, the following adjustments can be calibrated via the reset button:

Calibration of the seat is necessary for the following functions:

Position output of forward / back adjustment of the seat

The calibration of the forward / back adjustment of the seat is relevant to safety. For the position handover to the ACSM control module, the distance of the seat to the front mechanical limit position is evaluated. If the current position of the forward / back adjustment of the seat is before or on the codable value (”Schwelle_von_vorn”), the seat module detects a position in the front area.

If the current position of the forward / back adjustment of the seat is behind the codable value (”Schwelle_von_vorn”), the seat module detects a position in the rear area. After successful calibration, the adjustment counter is set to 0.
After 2800 adjustments, a Check Control message is issued for the required calibration. After 3000 adjustments, the calibration is cancelled. A fault memory entry is created in the seat module and in the Crash Safety Module.

Adaptation

During the adaptation, the mechanical resistances of the forward / back adjustment of the seat across the entire adjusting path forward and back are written into a characteristic map. This enables detection of obstacles during forward / back adjustment of the seat and the adjustment is cancelled. In the case of a seat without adaptation, the cutoff threshold is 50% higher.

Execution of seat calibration

The calibration can be carried out manually as follows:

Manual calibration

If there is a Check Control message, the customer can calibrate the forward / back adjustment of the seat by adjusting the seat in the mechanical end stop. The switch must be operated until the adjustment is deactivated by the control module.

Calibration via diagnosis

In Service, the calibration must generally be executed per diagnosis, as the required parameters of the seat are calibrated and adapted depending on the equipment version.

Calibration functions

 

Seat on driver's side

Seat on passenger's side

Seat, driver's side, rear

Seat, passenger's side, rear

Force limitation

X

X

 

 

Personal Profile

X

 

 

 

Seat position handover

X

X

 

 

Crash data memory

X

X

 

 

Collision with back shelf
(= rear window shelf)

 

 

X

X

Collision with seat fan

 

 

X

X


Requirements for seat calibration

No liability can be accepted for printing or other faults. Subject to changes of a technical nature