WDSBMW wiring diagrams
← Back

Footwell module

Footwell Module

The footwell module (FRM) is an electrical nodal point in the footwell on the driver's side. The footwell module activates the lighting, the front power windows and the outside mirrors. It picks up the signals of the doors, of the switch block in the driver's door and the height-level sensors. The footwell module also controls the adaptive headlights. The footwell module is also the interface to the dashboard.

Brief description of components

The following components deliver signals for the footwell module:

A number of control modules are involved in the lighting system. In a stricter sense, the following control modules are involved in the lighting (in alphabetical order):

The following components are activated by the footwell module:

System functions

The following functions are executed by the footwell module:

Gateway between LIN bus and K-CAN

The footwell module (FRM) enables communication to take place between the LIN bus and the K-CAN. The footwell module transmits messages on the other bus.

Components on the LIN bus:

Waking by means of various signals

The footwell module (FRM) can be wakened via the following signals:

Other functions

The footwell module (FRM) influences various functions in the vehicle. The following components are controlled by the footwell module:


Notes for Service department

Nearly all Car and Key Memory functions are programmed inside the vehicle itself. (See ”Personal Profile” in the Owner's Manual: individual settings for a maximum of 3 remote control modules via the display in the instrument cluster or via the Central Information Display)


Switch-on conditions

The footwell module (FRM) receives a large number of input signals that switch on the interior lighting. The input signals are read in directly by the footwell module or received via the K CAN.

The following signals switch the interior lighting ON:

The interior lighting is switched off under the following conditions:

As of terminal R Off, the interior lighting is switched off by the footwell module (FRM) after 8 minutes. To do so, the footwell module sends the message for consumer shutdown via the K CAN. The roof function centre (FZD) receives this message and switches the interior lighting off in the roof area. The interior lighting that is switched on directly by the footwell module is also switched off.

The footwell module provides terminal 58 g via the K CAN or via conventional wiring. Terminal 58 g is pulse-width modulated and has 2 brightness stages.

As soon as the hazard-warning switch has been pressed, the lighting of the hazard-warning switch is switched to full brightness by the footwell module. At terminal 58 g, the hazard-warning switch is not lit up with full brightness. The brightness depends on the setting for the locating lights.

 

No liability can be accepted for printing or other faults. Subject to changes of a technical nature