WDSBMW wiring diagrams
← Back

Functional description for trailer module AHM_01

Functional description for trailer module AHM_01

The trailer module is an auxiliary control module for the footwell module.
The trailer module is fitted if the vehicle is equipped with a trailer coupling. The trailer coupling is a fully automatic trailer coupling.

Component description

Alongside a microprocessor, the trailer module consists essentially of overload-resistant sense FET power circuit breakers for the trailer power circuits. The sense outputs of the power circuit breakers enable monitoring of the power circuits for excess current or wire breaks. Also implemented is an input for direct activation of the stop lamp by the stop lamp power circuit of the towing vehicle (hard-wired). The emergency function guarantees the function of the stop lamp on failure of the CAN bus. The trailer module controls and monitors the current circuits of the trailer. The trailer module also separates the current circuits of the trailer from the vehicle network of the towing vehicle. In the event of system faults, the trailer module creates the Check Control messages. The trailer module detects overvoltage and undervoltage in the vehicle network. Outside the valid range of 9 to 15 Volts, functions that are not relevant to safety are switched off. The control module for the fully automatic trailer coupling is required for operation. The control module is connected to the vehicle network by one 16-pin and one 4-pin connector. It has no direct connection to the bus system, but rather a LIN bus connection to the trailer module. The fully automatic trailer coupling is operated using a button in the luggage compartment. The control module is not programmable.

System functions

 

Information on encoding / programming
After installation of a trailer module, the control module must be recoded. In doing so, observe the various national versions.

 

No liability can be accepted for printing or other faults. Subject to changes of a technical nature