WDSBMW wiring diagrams
← Back

RDC transmitter, rear left

RDC transmitter, rear left

The RDC transmitter is a component of the Tyre Pressure Monitor (RDC).
In total, 4 RDC transmitters are installed (front left, front right, rear left and rear right).
The 4 RDC transmitters are identical components.

The tyre pressure monitor is a system for monitoring the tyre pressure while the vehicle is being driven. It is offered exclusively in the USA (legal requirement) and as an optional extra in Canada.
At the request of the RDC control module (in cycles of 54 seconds), a message is queried via the RDC transmitters (125 kHz) by each wheel electronics system (mounted in the wheel drop centre). The message is then sent across a high-frequency transmission path (433 MHz) to the RDC antenna.

Among other things, this message contains the following information:

The received radio signal are converted into a digital signal in the RDC antenna. This digital signal is forwarded on the bus to the RDC control module.

Functional description

The RDC control module sends a request to the RDC transmitters as a digital signal. Each RDC transmitter has its own electronics as well as its own data line to the RDC control module.
In each RDC transmitter, the digital signal is converted into a radio signal. Subsequently, the RDC transmitters send the request telemetrically to the wheel electronics systems in the wheels.

GR_FB3608002

Index

Explanation

Index

Explanation

1

RDC transmitters

2

4-pin plug-in connection


Structure and inner circuit

All 4 pins at each plug-in connection are used. The outside pins are earth connections. The inner pins are power supply and signal cable. The two earth connection are connected on a board in the electronic module. Only 3 cables are used in the wiring harness.

GR_FB3608004

Index

Explanation

Index

Explanation

1

Transmitter antenna

2

Transmitter

3

Electronic module with electronic evaluation unit

4

Data interface


Pin assignments

Pin

Explanation

Kl. 31

Terminal 31, earth connection

12 V

12 Volts, power supply

SIG

Signal line

Kl. 31

Terminal 31, earth connection


Target values

Observe the following target values for the RDC transmitters:

Variable

Value

Voltage range

8 to 18 V

Current consumption (passive)

10 mA

Current consumption (active)

230 mA

Transmission frequency

125 ± 6 kHz

Radio data rate

< 0.5 kBaud

Temperature range

-40 to 105 °C


Diagnosis instructions

Failure of the component:

If a RDC transmitter fails, the following behaviour is to be expected:

No liability can be accepted for printing or other faults. Subject to changes of a technical nature