Engine ventilation heating
Engine ventilation heating
The diesel engine has engine ventilation heating. The engine ventilation heating is at the entry to the fresh air pipe. Engine ventilation heating is an optional extra (optional extra 842 cold country version).
Functional description
The engine ventilation heating is required in countries with very low temperatures in winter to prevent the ventilation line from freezing. At constant speed and temperatures below -25 °C as well as with extreme short-distance driving, the line into the intake system can freeze. A heating element based on the PTC principle is used.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Blow-by pipe on the fresh air pipe |
2 |
Engine ventilation heating |
3 |
2-pin plug-in connection |
|
|
Structure and inner circuit
Resistors with a positive temperature coefficient (PTC) are referred to as cold conductors. The warmer the PTC becomes, the higher its resistance. With a PTC, high current flows on switching on, for example. With increasing heat, this level of current falls. Metals are PTC conductors. With rising temperature, their resistance increases.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Heating element for engine ventilation heating |
|
|
Pin assignments
The engine ventilation heating is supplied with terminal 15N by the junction box. The Digital Diesel Electronics (DDE) activate the engine ventilation heating on the earth side.
Pin |
Explanation |
|---|---|
Terminal 15N |
Power supply, terminal 15N |
Kl. 31E |
Activation (ground) of engine ventilation heating |
Conditions required for switch-on and target values
The engine ventilation heating is activated under the following conditions:
- Terminal 15 ON
- Ambient temperature less than 2 °C
- Time after engine start less than 360 seconds (time is extended depending on engine oil temperature, coolant temperature as well as driving speed)
Observe the following target values for the engine ventilation heating:
Variable |
Value |
|---|---|
Power supply |
12 V |
Resistance at 25 °C |
12 to 18 |
Temperature range |
-40 to 140 °C |
Diagnosis instructions
Failure of the component
If the engine ventilation heating fails, the following behaviour is to be expected:
- Fault memory entry in engine management
No liability can be accepted for printing or other faults. Subject to changes of a technical nature