Footwell temperature sensor, rear right
Footwell temperature sensor, rear right
The rear right footwell temperature sensor is a component of the rear automatic climate control (FKA) and it controls the rear air conditioning (with left / right separation).
The sensor measures the delivery temperature directly in the right footwell air outlet in the rear.
A total of 2 rear footwell temperature sensors are installed (left and right). The 2 rear footwell temperature sensors are identical components.
The FKA control module evaluates the signal from the rear right footwell temperature sensor. The signal is sent as a message on the CAN bus. The IHKA control module uses this message to regulate the rear right footwell-flap motor.
If required, the FKA control module switches on the heating element (PTC principle) in the right footwell ventilation duct. This enables additional heating of the air flow.
Functional description
The rear footwell temperature sensor is a hot conductor or NTC resistor (”NTC” stands for ”Negative Temperature Coefficient”).
The hot conductor means that the variable ”temperature” can be converted into the variable ”resistance” which can be electrically evaluated. The current-conducting materials in the hot conductor conduct current better at high temperatures than at low temperatures. That means: With rising temperatures, the resistance falls.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Rear footwell temperature sensor |
2 |
3-pin plug-in connection |
Structure and inner circuit
The rear footwell temperature sensor is supplied with 5 Volts by the FKA control module. In order to balance out internal temperature effects, the hot conductor is operated with low current. This means that the outer ambient temperature is decisive for the resistance value.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Hot conductor |
|
|
Pin assignments
Pin |
Explanation |
|---|---|
5 V |
Power supply |
Kl. 31E |
Terminal 31, electronics earth |
Characteristic curve and target values
Each temperature change at the hot conductor leads to a change in the voltage signal. The evaluation takes place in the FKA control module.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Temperature in degrees Celsius (°C) |
2 |
Characteristic curve for hot conductor |
3 |
Resistance in Kiloohms (k) |
|
|
Observe the following target values for the right rear footwell temperature sensor:
Variable |
Value |
|---|---|
Power supply |
5 V |
Temperature range |
-40 to 85 °C |
Resistance range (measuring range) |
1.2 to 100 k |
Diagnosis instructions
Failure of the component:
If the right rear footwell temperature sensor fails, the following behaviour is to be expected:
- Fault memory entry in the FKA control module
- Substitute value from the FKA control module: 20 °C
No liability can be accepted for printing or other faults. Subject to changes of a technical nature