Charge-air pressure sensor
Charge-air pressure sensor
The charge-air pressure sensor is bolted onto the intake air collector.
The sensor delivers the absolute pressure of the charge air to the Digital Diesel Electronics (DDE) (total of charge-air pressure and ambient pressure).
The purpose of the charge-air pressure sensor is charge-air pressure control.
Functional description
Expansion measurement strips are used to detect the pressure.
The pressure applied deforms a steel membrane in the sensor that is fitted with expansion measurement strips. The changes in resistance in the expansion measurement strips are detected electronically by a measurement bridge and evaluated. The measured voltage is then included as an actual value in the charge-air pressure control.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Intake air collector |
2 |
Charge-air pressure sensor |
3 |
3-pin plug-in connection |
|
|
Structure and inner circuit
The charge-air pressure sensor is connected by means of a 3-pin plug-in connection.
The sensor is supplied with 5 Volts and ground by the engine management system.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Charge-air pressure sensor |
|
|
Pin assignments
Pin |
Explanation |
|---|---|
SIG |
Charge-air pressure signal |
5 V |
5 Volts, power supply |
Kl. 31E |
Terminal 31, electronics earth |
Characteristic curve and target values
The charge-air pressure information is sent to the engine management system across a signal line.
The signal for the charge-air pressure, which can be evaluated, fluctuates depending on the pressure. The measuring range of approx. 0.1 to 0.9 Volts corresponds to a charge-air pressure of 50 kPa (0.5 bar) to 330 kPa (3.3 bar).

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Voltage |
2 |
Charge-air pressure characteristic curve |
3 |
Temperature |
|
|
Observe the following target values for the charge-air pressure sensor:
Variable |
Value |
|---|---|
Power supply |
4.75 to 5.25 Volts |
Measuring range for charge-air pressure |
0.5 to 3.3 bar |
Sensor voltage |
0.1 to 0.9 V |
Maximum output current |
10 mA |
Temperature range |
-40 °C to 130 °C |
Diagnosis instructions
Failure of the component
If the charge-air pressure sensor fails, the following behaviour is to be expected:
- Fault memory entry in the engine control module
- Deactivation of charge-air pressure control
- Deactivation of charge-air pressure control
No liability can be accepted for printing or other faults. Subject to changes of a technical nature