Electric changeover valve for engine mount
Electric changeover valve for engine mount
The electric changeover valve is attached to the underside of the intake air collector.
The electric changeover valve activates the controllable engine mounts. The controllable engine mounts achieve the following:
- They insulate the car body from vibrations as well as possible when the vehicle is at a standstill and idling
- They prevent 'bouncing' when the vehicle is being driven on poor road surfaces
('bouncing' = 'dancing' of the engine mass on the engine mounts)
Functional description
The engine management system activates the electric changeover valve. The changeover valve applies a partial vacuum to the engine mounts or switches the partial vacuum off. Depending on the partial vacuum applied, a soft or hard characteristic is set at the engine mounts. The partial vacuum is generated by the vacuum pump at the engine. The partial vacuum is fed to the engine mounts through hose lines.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Electric changeover valve for engine mount |
2 |
2-pin plug-in connection |
3 |
to the engine mount |
4 |
from the distributor |
Structure and inner circuit
There is a partial vacuum and ambient pressure at the electropneumatic changeover valve. Depending on activation from the Digital Diesel Electronics, the partial vacuum in the system is switched through to the partial-vacuum canister. Only the positions open or closed are possible.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Electric changeover valve for engine mount |
|
|
Pin assignments
Pin |
Explanation |
|---|---|
Kl. 15N |
Terminal 15, power supply |
SIG |
Activation of electric changeover valve |
Activation and target values
The following threshold values must be met for activation:
- Low driving speed (under around 60 km/h)
- Engine speed approximately between 1000 rpm and 1200 rpm (depending on the coolant temperature)
Both the threshold value for the driving speed and for the engine speed must be met.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Right engine mount |
2 |
from electric changeover valve |
3 |
Left engine mount |
4 |
vacuum line |
Observe the following target values for the electric changeover valve for the engine mount:
Variable |
Value |
|---|---|
Voltage range |
9 to 16 V |
Operating pressure |
0.8 to 1.5 bar |
Current consumption |
0.55 A |
Temperature range |
-40 to 140 °C |
Diagnosis instructions
Failure of the component
If the electric changeover valve for the engine mount fails, the following behaviour is to be expected:
- Fault memory entry in the engine control module
No liability can be accepted for printing or other faults. Subject to changes of a technical nature