Rail pressure sensor
Rail pressure sensor
The rail-pressure sensor is bolted onto the end of the fuel-distribution pipe (rail).
This sensor delivers the fuel delivery pressure after the high-pressure pump to the engine management system.
The purpose of the rail-pressure sensor is rail pressure control. The signal from the rail-pressure sensor is an important input signal of the engine management system for activation of the flow regulating valve as well as the rail-pressure regulating valve. The flow regulating valve is a component of the high-pressure pump.
Functional description
Expansion measurement strips are used to detect the pressure.
The pressure applied deforms a steel membrane in the sensor that is fitted with expansion measurement strips. The changes in resistance in the expansion measurement strips are detected electronically by a measurement bridge and evaluated. The measured voltage is then included as an actual value in the rail pressure control
.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
3-pin plug-in connection |
2 |
Rail pressure sensor |
3 |
Rail-pressure regulating valve |
4 |
Fuel-distribution pipe (rail) |
Structure and inner circuit
The rail-pressure sensor is connected by means of a 3-pin plug-in connection.
The sensor is supplied with 5 Volts by the engine management system.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Rail pressure sensor |
|
|
Pin assignments
Pin |
Explanation |
|---|---|
SIG |
Rail pressure signal |
5 V |
5 Volts, power supply |
Kl. 31E |
Terminal 31, electronics earth |
Characteristic curve and target values
The rail pressure information is sent to the engine management system across a signal line.
The signal for the rail pressure, which can be evaluated, fluctuates depending on the pressure. The measuring range of approx. 0.5 to 4.5 Volts corresponds to a rail pressure of 0 kPa (0 bar) to 180 kPa (1800 bar).

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Voltage |
2 |
Characteristic curve for rail pressure |
3 |
|
|
Observe the following target values for the rail-pressure sensor:
Variable |
Value |
|---|---|
Power supply |
4.75 to 5.25 Volts |
Voltage range for rail-pressure sensor |
0.5 to 4.5 Volts |
Measuring range of rail pressure |
0 to 1800 bar |
Maximum output current |
15 mA |
Temperature range |
-40 °C to 130 °C |
Diagnosis instructions
Failure of the component
If the rail-pressure sensor fails, the following behaviour is to be expected:
- Fault memory entry in the engine control module
- Emergency operation with substitute value
No liability can be accepted for printing or other faults. Subject to changes of a technical nature