Height-level sensor, front left and front right
Height-level sensor, front left and front right
The 2 height-level sensors are installed on the front axle (as series standard). The height-level sensor is attached by means of a bracket near the upper control arm.
There are only 1-channel sensors on the front axle. The sensors deliver the signal to the Integrated Chassis Management (ICM). The implements the signal on the FlexRay.
Functional description
The height-level sensor is a non-contact sensor.
The height-level sensor proportionally converts distances into an analogue voltage signal using an angle of rotation. The sensor can be rotated by 360°. The measuring range is 70° (depending on the installation location, See also 'Characteristic curve'). The signals are output as analogue electrical voltages.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Coupling bar |
2 |
Height-level sensor |
3 |
6-pin plug-in connection |
|
|
The coupling bar converts the wheel lift into a rotary motion at the height-level sensor.
As the spring compresses and rebounds, the output voltage for the of the height-level sensor changes linearly. On compression, the output voltage rises. On rebound, the output voltage falls (front right exactly vice versa, determined by the installation location)
Structure and inner circuit
The 2-channel height-level sensor consists of:
- Housing
- Ring magnet
- 1 Hall sensors
- 1 electronic evaluation unit

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Ring magnet |
2 |
Hall-effect sensor |
3 |
Electronic evaluation unit |
|
|
Pin assignments
Pin |
Explanation |
|---|---|
Terminal 31 |
Ground connection |
5 V |
5 Volts, power supply |
SIG |
Signal |
Characteristic curve and target values
The height-level sensor is supplied with 5 Volts by the ICM control module.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Signal voltage |
2 |
Installation location, front left |
3 |
Installation location, front right |
4 |
Characteristic curve, front left height-level sensor |
5 |
Characteristic curve, front right height-level sensor |
6 |
Angle of rotation in degrees |
Observe the following target values for the height-level sensor:
Variable |
Value |
|---|---|
Power supply |
4.5 to 5.5 V |
Output voltage at the sensor output in the event of failure of the power supply |
max. 2% |
Output voltage at the sensor output in the event of interruption of the earth lead |
min. 98% |
Overvoltage |
max. 18 V |
Short circuit protection (all pins) |
max. 16 V |
Maximum constant current consumption per channel (at U = 5.5 Volt) |
16 mA |
ON current (at U = 5.5 Volt) |
20 mA |
Diagnosis instructions
Failure of the component
If the height-level sensor fails, the following behaviour is to be expected:
- Fault memory entry in the ICM
- No control operation of the vertical dynamics management
- No headlamp range control
- No control operation of the ride-height control
Service functions
Important! Run a calibration of the height-level sensors.
After replacement of the control module (EHC, ICM) as well as of a height-level sensor, the calibration values of the height-level sensors must be relearned. The service function ”ride-height calibration” on the BMW diagnosis system must be used.
No liability can be accepted for printing or other faults. Subject to changes of a technical nature