Charge-air pressure sensor
Charge-air pressure sensor
The charge-air pressure sensor is bolted onto the intercooler.
This sensor delivers the pressure of the charge air (absolute) before the throttle valve to the engine management system.
The purpose of the charge-air pressure sensor is charge-air pressure control. The engine control module also uses the signal of the intake-manifold pressure sensor to calibrate the position of the throttle valve.
Functional description
Expansion measurement strips are used to detect the pressure.
The pressure applied deforms a steel membrane in the sensor that is fitted with expansion measurement strips. The changes in resistance in the expansion measurement strips are detected electronically by a measurement bridge and evaluated. The measured voltage is then included as an actual value in the charge-air pressure control.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Charge-air pressure sensor |
2 |
4-pin plug-in connection |
3 |
Intercooler |
|
|
Structure and inner circuit
The charge-air pressure sensor is connected by means of a 4-pin plug-in connection.
The sensor is supplied with 5 Volts by the engine management system.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Charge-air pressure sensor |
|
|
Pin assignments
Pin |
Explanation |
|---|---|
SIG |
Charge-air pressure signal |
5 V |
5 Volts, power supply |
Kl. 31E |
Terminal 31, electronics ground |
Characteristic curve and target values
The charge-air pressure information is sent to the engine management system across a signal line.
The signal for the charge-air pressure, which can be evaluated, fluctuates depending on the pressure. The measuring range of approx. 0.5 to 4.5 Volts corresponds to a charge-air pressure of 20 kPa (0.2 bar) to 250 kPa (2.5 bar).

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Voltage |
2 |
Charge-air pressure characteristic curve |
3 |
Temperature |
|
|
Observe the following target values for the charge-air pressure sensor:
Variable |
Value |
|---|---|
Voltage range for charge-air pressure sensor |
0.5 to 4.5 Volts |
Measuring range for charge-air pressure |
0.2 to 2.5 bar |
Maximum output current |
10 mA |
Temperature range |
-40 °C to 130 °C |
Diagnosis instructions
Failure of the component
If the charge-air pressure sensor fails, the following behaviour is to be expected:
- Fault memory entry in the engine control module
- Emergency operation with substitute value
No liability can be accepted for printing or other faults. Subject to changes of a technical nature