WDSBMW wiring diagrams
← Back

Heating heat exchanger temperature sensor, right

Heating heat exchanger temperature sensor, right

The right heating heat exchanger temperature sensor is a component of the integrated heating / air-conditioning system (IHKA) with left-right separation.
The sensor measures the delivery temperature directly at the delivery side of the heat exchanger for heating system on the passenger's side.

A total of 2 heating heat exchanger temperature sensors are installed (on the delivery side of the heat exchanger for heating system to the driver's side and on the delivery side to the passenger's side). The 2 heating heat exchanger temperature sensors are identical components.

The IHKA control module evaluates the signal from the right heating heat exchanger temperature sensor. The IHKA control module uses this message to regulate the front right stratifying-flap motor.

Functional description

The heating heat exchanger temperature sensor is a hot conductor or NTC resistor (”NTC” stands for ”Negative Temperature Coefficient”).
The hot conductor means that the variable ”temperature” can be converted into the variable ”resistance” which can be electrically evaluated. The current-conducting materials in the hot conductor conduct current better at high temperatures than at low temperatures. That means: With rising temperatures, the resistance falls.

GR_FB6408021

Index

Explanation

Index

Explanation

1

Heating heat exchanger temperature sensor

2

2-pin plug-in connection

Structure and inner circuit

The heating heat exchanger temperature sensor is supplied with 5 Volts by the IHKA control module. In order to balance out internal temperature effects, the hot conductor is operated with low current. This means that the outer ambient temperature is decisive for the resistance value.

GR_FB6508020

Index

Explanation

Index

Explanation

1

Hot conductor

 

 


Pin assignments

Pin

Explanation

5 V

Power supply

Kl. 31E

Terminal 31, electronics ground


Characteristic curve and target values

Each temperature change at the hot conductor leads to a change in the voltage signal. The evaluation takes place in the IHKA control module.

GR_FB6408022

Index

Explanation

Index

Explanation

1

Temperature in degrees Celsius (°C)

2

Characteristic curve for hot conductor

3

Resistance in Kiloohms (k)

 

 


Observe the following target values for the heating heat exchanger temperature sensor:

Variable

Value

Power supply

5 V

Temperature range

-40 to 85 °C

Resistance range (measuring range)

1.2 to 100 k


Diagnosis instructions

Failure of the component:

If the right heating heat exchanger temperature sensor fails, the following behaviour is to be expected:

 

No liability can be accepted for printing or other faults. Subject to changes of a technical nature