Temperature sensor on the radiator outlet
Temperature sensor on the radiator outlet
The temperature sensor is clipped into the coolant line on the radiator outlet.
The temperature sensor converts the temperature of the coolant after the radiator - and thus of the engine oil - into an electrical variable (resistance). To do so, a resistor with negative temperature coefficient (NTC) is used.
The coolant temperature is, among other things, the measured variable e.g. for the following calculations: injection quantity and nominal idle speed.
Functional description
A temperature-dependent electrical resistor is used for temperature detection. The circuit contains a power diplexer where the resistance can be measured depending on the temperature. This is converted into a temperature using a characteristic curve that is specific to the sensor.
A hot conductor (NTC) is installed in the temperature sensor; the resistance value of this hot conductor falls with rising temperature.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Temperature sensor on the radiator outlet |
2 |
Coolant line radiator outlet |
3 |
2-pin plug-in connection |
|
|
The resistance changes depending on the temperature from 167 k to 150 , which corresponds to a temperature of -40 °C to 130 °C.
Structure and inner circuit
The temperature sensor is connected by means of a 2-pin plug-in connection.
The resistor is part of a voltage divider circuit that is supplied with 5 Volts by the engine management system.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Hot conductor |
|
|
Pin assignments
Pin |
Explanation |
|---|---|
Kl. 31E |
Terminal 31, electronics ground |
5 V |
5 Volts, power supply |
Characteristic curve and target values
The electrical voltage at the resistor depends on the coolant temperature. A table that specifies the associated temperature for each voltage value is stored in the engine management system. This compensates for the non-linear relationship between electrical voltage and temperature.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Voltage |
2 |
Characteristic curve for hot conductor (NTC) |
3 |
Temperature |
4 |
|
Observe the following target values for the temperature sensor at the radiator outlet:
Variable |
Value |
|---|---|
Nominal resistance at 25 °C |
2252 ± 1.5 % |
Current consumption |
1 mA |
Response time |
15 s |
Resolution of temperature |
± 1 °C |
Maximum output current |
20 mA |
Temperature range |
-40 °C to 150 °C |
Diagnosis instructions
Failure of the component
If the temperature sensor at the radiator outlet fails, the following behaviour is to be expected:
- Fault memory entry in the engine control module
- Emergency operation with substitute value
No liability can be accepted for printing or other faults. Subject to changes of a technical nature