Fuel filter heating
Fuel filter heating
The fuel filter heating is connected to the fuel filter housing and fixed with a retaining clip. The fuel flows through the fuel filter heating into the fuel filter.
As winter diesel remains liquid even at low temperatures, the fuel filter heating is normally not active if the vehicle is operated with winter diesel.
Functional description
The Digital Diesel Electronics (DDE) switch the fuel filter heating on and off.
The fuel filter heating is switched on when the following conditions are met simultaneously:
- The electrical power output of the fuel pump is higher than the stored adaptation value plus an offset for more than 3 seconds. The offset is determined from a characteristic map and depends on the engine speed and fuel injection rate.
- Fuel temperature less than -1 °C
- Battery voltage greater than 9 Volts

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Fuel filter heating |
2 |
Fuel filter |
3 |
4-pin plug-in connection |
|
|
The fuel filter heating is switched off under the following conditions:
- Activation time greater than 5 minutes
- Fuel temperature greater than 8 °C
- Battery voltage less than 9 Volts for more than 30 seconds
Structure and inner circuit
The fuel filter heating is connected by means of a 4-pin plug-in connection.
The junction box supplies the fuel filter heating with 12 Volts.
At the same time, the fuel filter heating is set to ground.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Fuel filter heating |
|
|
Pin assignments
Pin |
Explanation |
|---|---|
Kl. 30 |
12 Volts, power supply |
SIG |
Activation of fuel filter heating |
Kl. 31 |
Ground connection |
Target values
Observe the following target values for the fuel filter heating:
Variable |
Value |
|---|---|
Voltage range |
6 to 16 V |
Maximum heat output |
360 W |
Average fuel throughput |
210 l/h |
ON current |
Less than 36 A |
Temperature range |
-40 °C to 90 °C |
Diagnosis instructions
Failure of the component
If the fuel filter heating fails, the following behaviour is to be expected:
- Fault memory entry in the engine control module
No liability can be accepted for printing or other faults. Subject to changes of a technical nature