WDSBMW wiring diagrams
← Back

Seat cushion heating for driver and/or passenger

Seat cushion heating for driver and/or passenger

Seat heating serves to set up a pleasant temperature in the backrest and seat cushion.

The seat heating includes backrest heating and seat cushion heating.

The seat cushion heating for driver and/or passenger consists of a seat heating pad installed in the seat cushion with an integrated temperature sensor.
The temperature sensor in the backrest enables varied distribution of the heating effect on the seat cushions and backrest via iDrive.

Functional description

The seat heating can be switched on separately for the driver's and passenger's seat as of terminal 15 On using the buttons in the control panel of the IHKA (automatic climate control).
The IHKA control module processes each button signal and sends a message across the K-CAN (body CAN) to the driver seat module (SMFA) and/or passenger seat module (SMBF).

The first time the button for the seat heating is pressed the seat module activates the seat heating and thus the seat cushion heating. Heating stage 3 (high heat output) is switched on. Further button pressures switch on the next-lowest heating stages 2 and 1 (medium and low heat output) or switch off the seat heating.

Depending on the selected heating stage, the seat module generates a pulse-width modulated signal (PWM signal) that is used to activate the seat heating pad in the seat cushion.
The seat cushion heating is monitored by a temperature sensor (NTC resistor).

GR_FB5208011

Index

Explanation

Index

Explanation

* The number of heater elements depends on the seat version

1

Temperature sensor in the backrest

2

Temperature sensor in the seat cushion

3

Heater element in the thigh support*

4

Heater element in the beads of the seat cushion*

5

Heater element in the seat cushion*

6

Heater element in the beads of the backrest*

7

Heater element in the backrest*

 

 


Structure and inner circuit

The seat heating pad is made of carbon fibre.

 

GR_FB5208016

Index

Explanation

Index

Explanation

1

temperature sensor

2

Seat heating pad with heater elements (number of heater elements depends on the seat version)

Pin assignments

Pin

Explanation

U

Power supply via seat module

Terminal 31L

Terminal 31, load ground

SIG

Signal line (signal from temperature switch)


Target values

Comply with the following target values for the seat cushion heating for the driver and/or passenger:

Variable

Value

Voltage range

9 to 16 V

Clocking of the PWM signal

25 Hz

Maximum surface temperature at the seat heating pad (shutdown by seat module)

42 °C

Temperature range

-40 to 85 °C


Diagnosis instructions

Failure of the component

If the seat cushion heating for the driver and/or passenger fails, the following behaviour is to be expected:

General information

The energy management in the vehicle can activate the seat heating with reduced function or briefly switch it off depending on the energy balance. However, the function indicator is retained.
The heat output is reduced as follows:

No liability can be accepted for printing or other faults. Subject to changes of a technical nature