Backrest heating for driver and passenger
Backrest heating for driver and passenger
Seat heating serves to set up a pleasant temperature in the backrest and seat cushion.
The seat heating includes backrest heating and seat cushion heating.
The backrest heating for the driver and/or passenger consists of a seat heating pad installed in the backrest with an integrated temperature sensor.
The temperature sensor in the seat cushion enables varied distribution of the heating effect on the seat cushions and backrest via iDrive.
Functional description
The seat heating can be switched on separately for the driver's and passenger's seat as of terminal 15 On using the buttons in the control panel of the IHKA (automatic climate control).
The IHKA control module processes each button signal and sends a message across the K-CAN (body CAN) to the driver seat module (SMFA) and/or passenger seat module (SMBF).
The first time the button for the seat heating is pressed the seat module activates the seat heating and thus the backrest heating. Heating stage 3 (high heat output) is switched on. Further button pressures switch on the next-lowest heating stages 2 and 1 (medium and low heat output) or switch off the seat heating.
Depending on the selected heating stage, the seat module generates a pulse-width modulated signal (PWM signal) that is used to operate the seat heating pad in the backrest.
The backrest heating is monitored by a temperature sensor (NTC resistor).

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
* The number of heater elements depends on the seat version |
|||
1 |
Temperature sensor in the backrest |
2 |
Temperature sensor in the seat cushion |
3 |
Heater element in the thigh support* |
4 |
Heater element in the beads of the seat cushion* |
5 |
Heater element in the seat cushion* |
6 |
Heater element in the beads of the backrest* |
7 |
Heater element in the backrest* |
|
|
Structure and inner circuit
The seat heating pad is made of carbon fibre.

Index |
Explanation |
Index |
Explanation |
|---|---|---|---|
1 |
Seat heating pad with heater elements (number of heater elements depends on the seat version) |
2 |
temperature sensor |
Pin assignments
Pin |
Explanation |
|---|---|
U |
Power supply via seat module |
Terminal 31L |
Terminal 31L, load earth |
SIG |
Signal line (signal from temperature switch) |
Target values
Comply with the following target values for the backrest heating for the driver and/or passenger:
Variable |
Value |
|---|---|
Voltage range |
9 to 16 V |
Clocking of the PWM signal |
25 Hz |
Maximum surface temperature at the seat heating pad (shutdown by seat module) |
42 °C |
Temperature range |
-40 to 85 °C |
Diagnosis instructions
Failure of the component
If the backrest heating for the driver and/or passenger fails, the following behaviour is to be expected:
- Fault memory entry in the driver seat module (SMFA)
General information
The energy management in the vehicle can activate the seat heating with reduced function or briefly switch it off depending on the energy balance. However, the function indicator is retained.
The heat output is reduced as follows:
- Operation of the seat heating only in heating stage 2
- Operation of the seat heating in heating stage 2 with only 50% heat output
- Seat heating off
No liability can be accepted for printing or other faults. Subject to changes of a technical nature