WDSBMW wiring diagrams
← Back

Switch for passenger's airbag deactivation

Switch for passenger's airbag deactivation

The switch for the passenger's airbag deactivation is on the outside right of the dashboard. The switch is accessible when the front passenger's door is opened. The switch is operated using the key integrated into the remote control.

In the switch position ”OFF”, the following airbags on the passenger's side are not inflated:

The indicator lamp for passenger airbag deactivation (passenger's airbag off lamp) lights up.

Functional description

The current consumption of the switch for the passenger's airbag deactivation varies depending on whether the switch is in switch position ”ON” or ”OFF”.

GR_FB7208005

Index

Explanation

Index

Explanation

1

2-pin plug-in connection

2

Switch for passenger's airbag deactivation

The signal from the switch for the passenger's airbag deactivation is read in by the crash safety module (ACSM). ACSM stands for ”Advanced Crash Safety Module”, referred to as the crash safety module.

The switch for the passenger's airbag deactivation is monitored permanently by the crash safety module as of terminal R On.

Structure and inner circuit

The switch for passenger's airbag deactivation is supplied with interface across an interface by the crash safety module (ACSM). Data are transferred across a two-wire connection.

GR_FB7208006

Index

Explanation

Index

Explanation

1

Switches

2

Hall-effect sensor


Pin assignments

Pin

Explanation

SIG+

Signal line (+) and power supply

SIG-

Signal line (-)


Target values

Observe the following target values for the switch for passenger's airbag deactivation:

Variable

Value

Current consumption with switch position ”ON”, high side (positive side)

12 to 19 mA

Current consumption with switch position ”ON”, high side (positive side)

1.9 to 6 mA

Current consumption with switch position ”ON” low side (negative side)

-12 to -19 mA

Current consumption with switch position ”OFF” low side (negative side)

-1.9 to -6 mA

Temperature range

-40 to 85 °C

The interface in the crash safety module (ACSM) is pulsed. As these are not static values (the pulse is applied every 300 milliseconds for only 2 milliseconds), the values can only be measured using an oscilloscope.

Diagnosis instructions

Failure of the component

If the switch for the passenger's airbag deactivation fails, the following behaviour is to be expected:

 

No liability can be accepted for printing or other faults. Subject to changes of a technical nature